Search results

http://cgi.ebay.com/cue-lathe-/220797242675?pt=LH_DefaultDomain_0&hash=item33688a8d33#ht_500wt_1156

http://cgi.ebay.com/Full-Size-Cue-Smith-Pool-Cue-Lathe-Accessories-/170654799895?pt=LH_DefaultDomain_0&hash=item27bbd19817#ht_2844wt_1141 Wish i could get it

worked great worked great did a fast taper to see if i was close to were i wanted thanks you two next i going to start tapering own shafts is it the same as tapering butts Thanks Dale

Ok here it goes Can someone give me the measure off-set of taig tailstock to get close to a .842 at joint Still saving for tapering lathe Thanks Dale

Viking I have this http://forums.azbilliards.com/showthread.php?t=233917

Viking custom cue Bump for nice Viking custom cue

Buchanan custom sneaky Pete Bump for cheap cue Buy for $150 get free shipping in USA

http://cgi.ebay.com/cue-lathe-/220793863625?pt=LH_DefaultDomain_0&hash=item336856fdc9#ht_500wt_1156

60" Cue with Un-loc pin 30" Shaft with lepro tip 12.75 30" Butt with 8 inlays 18.5 oz Cue Has taper roll off on shaft Still play well $175 Or maybe trade on cue building supplies

Custom Viking Cue Has lots of inlays 2 Shafts stock 13mm predator 314 turned to 11.5 mm 19.5 oz It Cost a litlle over ($1200 to have built wife had it done before i started to build cues ) $650

mcdermott cue quick pin just the pin Thanks Dale

Ok was going to buy some sanding arbors had on order for last year now still don't have so ????? Can I use 303 stainless bar stock is it hard enough to sand on Thanks Dale

When i make carom cues yes sir when i make a carom cue i make a 1/2-8 wood pin

Pool cue lathe. new from tool and die shop. Power feed, double self centering chucks with 1.3 through hole. 110 volt. This was built custom for a cuemaker and never used. It has a few better features than all on the market (which I can't disclose here). No extra tooling. Extra long bed , approx...

Just was on ebay lookin for new bits and found this cue lathe Think i would stick with todd's lathe or chris's lathe http://cgi.ebay.com/CUSTOM-POOL-CUE-LATHE-DOUBLE-CHUCK-EXTRA-LONG-POWER-CUT-/320656886023?pt=LH_DefaultDomain_0&hash=item4aa8a3c907

Link The link I put up is not the same cue the l-e81 is an oldder cue

My old cue was this one This was the cue i used before making my own There were only 25 of these Limited Special Edition cues made. http://cgi.ebay.com/Lucasi-L-2007R-LTD-RADIAL-LINEN-WRAP-50-OFF-MSRP-/310103204053?pt=LH_DefaultDomain_0&hash=item48339760d5 one of the best places to buy...

I should have said this too because everyone is diffence

Headstock Bump to the top for awsome headstock

Pin Awesome cue and I bet it let's you play under the table and the balance point on shurtz cues are dead on your hands. Are you think of making your own cue?