Search results

Has anyone heard from or dealt with Koinkid...Troy lately? Sent a message and email and have not got a response.....hope all is well. Dave

first, that's NOT an authentic uni-loc joint pin. It is a knockoff. Secondly, you should put a ruler next to threads and maybe we can tell the TPI by the picture.

I only sand in one direction, basically a line, doing the circles will cause this to happen.

It has finally been confirmed that Tom Hay from Ultraskins has passed away. My Condolences to the family and friends that he left behind. He and I didn't start off good at the beginning, I asked questions and we butted heads. We finally got on the same page and he was a standup guy thru it all...

Cuefits sells the 2 taps, one is normal, the other is undersized

Every tap/tool I have bought from Cuefits has been spot on so far

Adams if I recall correctly, never glued their weight bolts, it is probably rust buildup as I mentioned before. One thing to try is to put it in a refrigerator for 10 or so hours and try the wrench in a vice method I mentioned before and see if that works. At 40ish degrees, no damage to the cue...

What I have found is that the bolts can rust a little over time, and and act like loctite threadlock. Heat works (as mentioned, an induction heater is the TOOL) and an sturdy allen wrench held in a vice, make sure the bottom of the 'L' is in the vice so it cannot turn. Then wrap a rubber...

I HIGHLY recommend using Veneer Tamer instead of water.....water will cause it to swell, then shrink, have had no swelling/shrinkage with veneer tamer. https://www.vacupress.com/product/veneer-tamer/...

I do. actually use the Unique leather fig to install it.

Thanks Mike for the kind words, I have done other build-ups since using the method I used on the above mentioned post using veneers and then after sanding, covered it with either linen or leather. The REAL game changer is a product called veneer tamer(woodcraft). Once the veneer is soaked...

do you mean the inside thread for the pin, or the outside thread of the barrel?

picture would help....

hydex202 is the same as isoplast.....basically unbreakable when applied to pool cue repairs. There is a guy on here, goes by Mase, that may be able to help.

Do you have any repair guys near you? It is a simple job to do, with the right knowledge and tools. I recommend using isoplast or hydex material for the new ferrule

I have been advised that the 11.5 comes sooooo close that it will work, so ordered that tap and will see. First time in 27 or so yrs of doing this I have ran across this REAL Bastard thread....and hopefully the last.

I have done it multiple times and, thankfully, the taps came back. Do you have the tap Mike? I would be willing to take the drive for you to do the tapping....

Had a customer bring me a stripped out shaft that turns out to be a Bludworth. I looked quick at it and thought it was 3/8x10.....NOT. My 3/8x11 drive collar screws down about 1.3 of the way then locks up. I am assuming it is a modified 11.5. Does anyone have the tap that I could borrow? I will...

Very sorry to hear about your health issues. You have been a GREAT part of the pool community in so many ways, your sales and service have always been top notch! and will be missed. I wish you success with the sale, and I hope your health issues get better!

Yes it is