Search results

Does anyone know of a cue builder named, Haro? TIA Eddie

I'm trying to find a single rail cushion for 7' valley dynamo pool table. Eddie

Periodically I have to move a 3-piece 8' pool table across the room approximately 6'-7'. Suggestions for an initial setup that will minimize the amount of table shifting while moving? Eddie

Saw this cue builder on Facebook. Has anyone ever had any dealings with Neil, or played with one of his cues?

Looking to trade a Meucci Black-dot shaft for a Meucci Pro-shaft, (or something very similar, for 5/16" x 18 joint pin), plus cash depending on condition, and brand. Eddie

Snooker pro Robert Milkins was taken to hospital after arriving at an event intoxicated. Milkins, who was celebrating his birthday, fell and cut himself after drinking heavily.

I just seen the news that a banana taped to a wall with duct tape, sold for $100,000 at auction. It was considered to be a rare work of art.

I'm looking for an aluminum weight bolt for an E series? McDermott cue that has the screw in rubber bumper. Eddie

........................

Hello Cuemakers and everyone. I have a question about the best wood to build a cue butt out of, (solid or spliced) for the best feel, most feedback or sensitivity, and sound. If I use the same shaft to test hit with, and with hard tip. I'm looking to have a 30" butt built with a 3/8" x 10 pin. Eddie

Hello. Has anybody ever played with a Sly Foxx cue, or know much about the cue builder? Thanks

Hello All. I have a tendency to drop my elbow when shooting. I've tried bending lower over the cue, and spreading out more on my stance, but it's really uncomfortable. What would be a good practice routine to break this habit? Thanks

Does anyone know when Audrick started making the custom cues? I have a 1/1 that appears to be a starter cue. The reason I say a "starter" cue is because of the construction of the butt. The shaft is nice and straight. The butt rings and handle are very uneven and cause it to wobble when it's...

Which one should I do, have nipple on shaft insert machined down, or ream the butt of the cue for shaft, and how much will it cost? Will either affect the hit of the cue?

I'm looking for an inexpensive, radial pin cue butt.

Hi to all. I sent a picture of a cue to itzel0101, and he's going to post it for me. I'm trying to find out what cue builder has a signature mark like the one on this cue. Thanks

I found the latch. Thanks

I'm looking for an inexpensive dealers 12x12 or 10x10 pool cue roll up bag. Thanks Eddie

I bought the cue new, (3-4 years?) a custom order from (David) at Scmelke cues. The butt of the cue is 33" (not including rubber bumper in length), 3/8"-10 pin, and weighs 15.2oz. I shot a few racks; (home table), finish is still like new, and it does roll straight. I also have the shaft that...

..................................