Search results

Shaft is scheduled to arrive today. The previous owner had a Zan Medium installed. I do like the Kamui Soft Black that comes on the V4's from Jacoby but it will be good to experiment with the Zan.

I can't answer your question regarding the 11.0mm. The smallest diameter shaft that I have used (shot/played with) has been a 12.2mm. I tried a Cuetec Avid 11.75 for a few shots but it felt too small. As for the V5, that is a question for Jacoby.

I am a fan of the Jacoby Black V4 shafts. I really like their 12.3's.

Thanks for the book recommendation. Ordered a copy just after reading this thread.

Found one. Ended up going with a 30". Fingers crossed it will be here middle of next week.

Thanks for the offer. I'm going to try to find one that is already in the Radial pin configuration but I will keep it in mind.

I'll keep it in mind but am really looking for a V4.

Very good advice for any buyer (or seller). I had neglected to look at the account status until you mentioned it.

Wanted: Jacoby Black V4 12.3mm for Radial pin. 29" or 30" (preference is 29"). Thanks, Bryan

If you use Ebay check there. I found new sets from $445-$500.

Think of these 2 things: Table consistency and familiarity Do you like the tables that you play on in your league?? What are they? Do you consistently play on one size and one brand of table in your league?? If you play league on 7 ft. Diamonds Blue Labels and you like a 7 ft. Diamond Blue...

Words to LOVE by???? Wronged, no. Insulted, no. But the whole" laying hands on me" during the love process makes it better in my opinion!!!! Just busting your chops Rusty!

I ended up cutting mine down. Bolt was heavy (5 oz.) and I was able to take it down to 3 oz. Took a dremel tool, a hacksaw and a file but got it done. And now in reading the post above from Cartune I remembered that we have a Fastenal store in town!!! May go by there and see if they have...

Thanks for the info. Appreciate the help.

I'm not "effing around". I asked a question that I hoped could be answered. Your smart ass response is uncalled for and not appreciated. Get off your high horse. Put me on your ignore list and I will put you on mine.

Stopped at Rural King earlier today but no luck. Planning to try Tractor Supply tomorrow, then Lowes, Home Depot and Menards. Luckily they are all located near each other!!

I can cut it down but really need a nut to thread onto it beforehand to help deburr the threads after the cut. Plus I would like to be more precise in how much weight I remove. Unfortunately the closest shop to me is an 85 mile round trip and won't be open until Monday. Unless I can figure...

I am using a Koda butt for my break cue setup. I want to drop some weight but cannot figure out the thread size on the weight bolt. Looks to be either a 1/2" or a 12mm but I cannot determine the thread pitch. Have tried different 12mm pitches and different 1/2"x20 threads but no luck.

I'll take #14.

Something is "off" with this Ebay seller. Not only is he showing an identical Predator Ikon for sale but he also listed an Adam cue in December that shows as sold and has automated feedback. However the same cue is back up for sale now.