Guys
I’m in the process of sanding my Anniversary solid wood rails. The old sights are cracked and needs replacement. On my previous table refinish I changed them after all the finishing was done. I had to redrill the holes a little deeper since I did removed some wood by sanding the rails. The fit was good around the sights but I’ve had hard time installing them perfectly flush with the top surface (using gel superglue). Now I’m wondering if it may works ok to install them prior to finishing and sanding them flush as required. I guess that I can clean them easily during staining but I wonder if putting polyurethane varnish on top will stick properly and/or looks good ?
Thanks for any input
Martin
I’m in the process of sanding my Anniversary solid wood rails. The old sights are cracked and needs replacement. On my previous table refinish I changed them after all the finishing was done. I had to redrill the holes a little deeper since I did removed some wood by sanding the rails. The fit was good around the sights but I’ve had hard time installing them perfectly flush with the top surface (using gel superglue). Now I’m wondering if it may works ok to install them prior to finishing and sanding them flush as required. I guess that I can clean them easily during staining but I wonder if putting polyurethane varnish on top will stick properly and/or looks good ?
Thanks for any input
Martin