That's nice!
im planning to do this on a mezz. SS has an id of about 16-17mm. outer is 21.4mm
making a Sleeved joint
- Thread starter CavinTan
- Start date
That's nice!
im planning to do this on a mezz. SS has an id of about 16-17mm. outer is 21.4mm
Thank you. The white joint is Ivory. I did it this way because I didn't want ivory against stainless. Turned out well.
Not exactly what i was asking in the OG thread,but similar to what you've posted...
link to the build here
Rest in peace Bill S.
3 plus years later. Lol
If you can turn the stainless joint safely down to .750, assuming the joint on the cue is finished .840 and you don't damage the inner construction of the stainless joint. Good epoxy will hold. If your turning down a stainless sleeve or as hits em hard stated, a Schon. You'll lose the stainless.
Anything else? 0r do we come back to this thread is 2026/27
Have a nice day!
Last edited:
Haha, sorry. Just wanted to share some pics that was similiar to your uniloc joint you posted
All good Mr. TanHaha, sorry. Just wanted to share some pics that was similiar to your uniloc joint you posted
Did you make the change?
Results?
i'll leave this one alone for now.. do not have a metal lathe anymore