Ed P
Registered
Hello all.
This may have come up before but I could not find it. When cutting down shafts and to prevent warping, is it better to seal the wood between cuts while letting them rest, or leave the wood natural? I have been using a sealer from Cue Components (Joe ) but seem to get some movement. Are there some sealers or products which may work better? I do cut small passes (.015 - .020) and give a month or more between passes. Sometimes several months depending on availability. Keep in mind, I do live in Florida. And I am not working out of a climate controled area.
Any input will be appreciated.
Thanks Ed.
This may have come up before but I could not find it. When cutting down shafts and to prevent warping, is it better to seal the wood between cuts while letting them rest, or leave the wood natural? I have been using a sealer from Cue Components (Joe ) but seem to get some movement. Are there some sealers or products which may work better? I do cut small passes (.015 - .020) and give a month or more between passes. Sometimes several months depending on availability. Keep in mind, I do live in Florida. And I am not working out of a climate controled area.
Any input will be appreciated.
Thanks Ed.