Narrow butt Handle ?

C

croscoe

Retired
Silver Member
Is there a reason for the butt not being a consistent diameter say 2" or so ahead of the wrap area to the butt cap?

If not is it feasible to do about 27.5 mm straight back?



Thanks
Charlie
 
JoeyInCali

JoeyInCali

Maker of Joey Bautista Cues
Silver Member
croscoe said:
Why?

Where would the flexing occur ?

This the same dia.as the beginning of the grip area.
Click to expand...

The beginning of the grip area is barely over an inch .
1.060" on the fat side . Most hover around 1.0" to 1.050".
The bottom hovers around 1.230" to 1.275".
That's a lot of wood and weight to take out .

And, there is not much demand for it .
Players are ok by the slight taper of two-piece cues.
House cues are a lot more conical in the grip area.
 
Michael Webb

Michael Webb

AzB Silver Member
Silver Member
The answer to your question is yes.. Sought of. John Robinson cues. I believe his son Greg runs the shop now and well as his own craft of building guitars. His cue spec's are in line with what your asking.
 
You must log in or register to reply here.
Top