06 Andy Gilbert
Butt:
15.6oz, 29", 5/16 14 SS half joint.
Shaft 1:
29", 4.0oz, 12.75mm, ivory ferrule
Shaft 2:
29", 4.0oz, 12.75mm, ivory ferrule
Balance point: 19.25/19.5
You are looking at a beautiful 06 Andy Gilbert that came out of a collection of bigger cues. This cue has had a pampered life and was more than likely stored in a safe and rarely used. I can not find one single ding or dent anywhere on the cue, it looks like it would if picked up new from Andy at his shop. Neither shaft has any blueing of any kind and tips look full and original.
This beauty of a cue features Andy's 1/2 SS 5/16 14 joint with thick silver ring work in black phenoilc below the joint and in the shaft collars. There is also a Buska ring above the classic white/green spec wrap that has white and black squares boardered by two thin silver rings. Above the Buska ring are 4 long points made of ebony and boardered by 4 veneers, black, red, blue/gray, and natural. The butt-sleeve is made of ebony and has a while delrin butt cap. You can see nice graining in both the points and the butt-sleeve. Either shaft has a minor bit or taper roll, absolutely nothing leaves the table, the butt is lazer straight. The only other issue I can find with any part of the cue, and this is being nitty, you can just barely feel the outter lip of the butt cap where it meets the butt sleeve.
Will consider Hoppe trades/R Schons/fair offers on this beautiful cue.
Butt:
15.6oz, 29", 5/16 14 SS half joint.
Shaft 1:
29", 4.0oz, 12.75mm, ivory ferrule
Shaft 2:
29", 4.0oz, 12.75mm, ivory ferrule
Balance point: 19.25/19.5
You are looking at a beautiful 06 Andy Gilbert that came out of a collection of bigger cues. This cue has had a pampered life and was more than likely stored in a safe and rarely used. I can not find one single ding or dent anywhere on the cue, it looks like it would if picked up new from Andy at his shop. Neither shaft has any blueing of any kind and tips look full and original.
This beauty of a cue features Andy's 1/2 SS 5/16 14 joint with thick silver ring work in black phenoilc below the joint and in the shaft collars. There is also a Buska ring above the classic white/green spec wrap that has white and black squares boardered by two thin silver rings. Above the Buska ring are 4 long points made of ebony and boardered by 4 veneers, black, red, blue/gray, and natural. The butt-sleeve is made of ebony and has a while delrin butt cap. You can see nice graining in both the points and the butt-sleeve. Either shaft has a minor bit or taper roll, absolutely nothing leaves the table, the butt is lazer straight. The only other issue I can find with any part of the cue, and this is being nitty, you can just barely feel the outter lip of the butt cap where it meets the butt sleeve.
Will consider Hoppe trades/R Schons/fair offers on this beautiful cue.
Attachments
Last edited:
