3/4" double angle v groove cutter

[leon sly]

FS: 3/4" double angle v groove cutter

sold~~~~~~~~

 

[whammo57]

Ok Leon..... I have to plead ignorance on this one.....

Why would you want an 88 deg cutter if you are going to put a 90 deg piece of wood in the groove?

Kim

 

[cuejo]

Shoot Leon, if that was a 1/4 shank I would snap it up.

 

[leon sly]

Ok Leon..... I have to plead ignorance on this one.....

Why would you want an 88 deg cutter if you are going to put a 90 deg piece of wood in the groove?

Kim

i use the 90 Deg cutter for the V groove & the 88 Deg to cut the miter on the veneer that's how i do it the miters are dead nuts tight on the fold i only have one cutter available. $ 75.00 shipped in the lower 48

 

[whammo57]

i use the 90 Deg cutter for the V groove & the 88 Deg to cut the miter on the veneer that's how i do it the miters are dead nuts tight on the fold i only have one cutter available. $ 75.00 shipped in the lower 48

AHHHH.... makes sense....

thanks

Kim

 

[GBCues]

Shoot Leon, if that was a 1/4 shank I would snap it up.

Darcy,

Get the 7/8" and simply turn it down!!!
Of course, you'd want a 1/2" steel shield between it and you when you spun it up!!!

Just kidding of course.
:thumbup:
Gary

 

[cuejo]

Darcy,

Get the 7/8" and simply turn it down!!!
Of course, you'd want a 1/2" steel shield between it and you when you spun it up!!!

Just kidding of course.
:thumbup:
Gary

Lol
I turned down a drill bit to fit my chuck once...... Hot sharp metal flying