3/8-9 joint pin

Ed Keeney · 2026-01-29T04:40:36-0700

Can so one tell me what cue makers use a 3/8-9 joint pin?? Ed

Kris_b1104 · 2026-01-29T06:02:18-0700

A 3/8x9 is used by Mezz on their Wavy joints. Don't know about custom cue makers.

Ed Keeney · 2026-01-29T06:21:53-0700

garczar said:
never heard of it. this will get a LOT more traction in the 'Ask a Cuemaker' section.

I think Mezz uses them. There wavy.
I was just wondering who else uses them??

Ed Keeney · 2026-01-29T07:08:41-0700

Can anyone tell me what cue makers use 3/8-9 thread joint pins??

Kim Bye · 2026-01-29T07:20:12-0700

Ed Keeney said:
Can so one tell me what cue makers use a 3/8-9 joint pin?? Ed

Tiger uses 3/8-9 ACME

iusedtoberich · 2026-01-29T14:36:07-0700

Another one? hahaha.

Does it look like a normal 3/8-10 only with a different pitch? Or is it a completely different thread form?

Kim Bye · 2026-01-30T06:18:25-0700

iusedtoberich said:
Another one? hahaha.

Does it look like a normal 3/8-10 only with a different pitch? Or is it a completely different thread form?

ACME has a square shaped thread, it's basically the same style of thread geometry you'll find on a lathe or mill leadscrew.