3/8 ten pin

[kaznj]

Are there different 3/8 10 pins. Someone told me that even though they are both called 3/8 10 that there are actually two different pins.
I bought a z2 shaft at the expo that did not fit on my 3/8 10 scrugs. Joe Blackburn drilled it out to make it fit.

 

[BHQ]

Are there different 3/8 10 pins. Someone told me that even though they are both called 3/8 10 that there are actually two different pins.
I bought a z2 shaft at the expo that did not fit on my 3/8 10 scrugs. Joe Blackburn drilled it out to make it fit.

he is correct ............................

 

[RBC]

he is correct ............................

Hey Brent, were'd you get that picture of a left hand flat bottom thread pin?


Royce

 

[BHQ]

Hey Brent, were'd you get that picture of a left hand flat bottom thread pin?


Royce

:rotflmao1:
secret supplier... hint: starts with A ends with S