3/8x10 pin

[fishcake]

what's the difference between flat face and a modified 3/8x10 pin?is there a any pros and cons between the two?thanks azb

 

[bbb]

....see below

 

[bbb]

if you did a search you would have found i asked that exact question
3 weeks ago......
thanks to all who responded to my thread:thumbup:
here is the link so they wont have to respond again:grin:
the picture posted by gary of gbcues taken from bob dzuricky very clearly explains the difference
and bob dzuricky of dz cues was kind enough to answered the pros and cons
http://forums.azbilliards.com/showthread.php?t=273934


hope you know im just teasing you and no disrespect intended:smile:

 

[dzcues]

what's the difference between flat face and a modified 3/8x10 pin?is there a any pros and cons between the two?thanks azb

Since this question is coming up a lot again, I posted the page again.

 

[bbb]

Since this question is coming up a lot again, I posted the page again.

bob
you are true gentlemen to answer the same question twice
:thumbup:

 

[bbb]

Since this question is coming up a lot again, I posted the page again.

bob do you have any pictures of a radial pin in a shaft???
from your link
is a unilock and a radial pin the same???

 

[jeff olney]

bob do you have any pictures of a radial pin in a shaft???
from your link
is a unilock and a radial pin the same???

A few pictures, both pins fit nice without being to tight. Do a search on pool cues parts joint pins. Unilock makes alot of pins the unilock itself i believe is their famous quick release, when people say unilock they are talking quick release the radial would be the unilock radial. the radial pins are very nice to work with the radial pin tap is great to use when tapping out shafts the pic shows the fit. the tap itself is made to tap dead straight as long as the hole is dead straight. Great design the lead threads are different than a normal tap. Jeff

 

[bbb]

A few pictures, both pins fit nice without being to tight. Do a search on pool cues parts joint pins. Unilock makes alot of pins the unilock itself i believe is their famous quick release, when people say unilock they are talking quick release the radial would be the unilock radial. the radial pins are very nice to work with the radial pin tap is great to use when tapping out shafts the pic shows the fit. the tap itself is made to tap dead straight as long as the hole is dead straight. Great design the lead threads are different than a normal tap. Jeff

thanks for the pic and reply
:thumbup: