I special ordered this .348" x 11.5 TPI #3 Tap from Widell Industries around '93. It was for a JP Set I had to make for LB's Cue I bought from him at the BCA Show..And then sold to a customer in Hawaii.
It's a standard V thread.. I didn't want to infringe on his "Patented" Design (Said with all due respect..
..)
I don't make LB Protectors so, If any cuemaker would like to buy it to make shafts or ??.. I only used it 4 times, and, to thread delrin, not metal, so, it's still "Factory Sharpened!!
$78.00 (Includes PayPal and USPS First Class Mail)
I tried to take the photo with the Widell engraved specs on the shank, but, my digital camera can't focus in on the numbers and the curve of the shank makes the lighting cross right over the information so, can't see it.
I just was looking in my Threading Tool Draw and found another .348" Tap. Same one. I must have ordered 2..
It's a standard V thread.. I didn't want to infringe on his "Patented" Design (Said with all due respect..
..)I don't make LB Protectors so, If any cuemaker would like to buy it to make shafts or ??.. I only used it 4 times, and, to thread delrin, not metal, so, it's still "Factory Sharpened!!
$78.00 (Includes PayPal and USPS First Class Mail)
I tried to take the photo with the Widell engraved specs on the shank, but, my digital camera can't focus in on the numbers and the curve of the shank makes the lighting cross right over the information so, can't see it.
I just was looking in my Threading Tool Draw and found another .348" Tap. Same one. I must have ordered 2..
Attachments
Last edited: