jordan11850
New member
Our local bar's pool table has some short cue areas. I bought a 36" one piece cue, are there cue cases for these?
36" pool cue case
- Thread starter jordan11850
- Start date
Mr. Joshua
Registered
A 40" soft rifle case for about $20 may be best. Probably better off replacing the cue than paying for a more expensive case.
Yeah, never seen a cue case for something that length. Custom builder could make you one for sure but would probably be cheaper and easier to have a joint put in the cue.
But, that cue also isn't legal. 40" minimum length for a cue. Now for bar pool likely nobody cares, but just pointing it out.
As an aside, this post made me realize something kinda handy. I have a Predator setup that is all Uniloc joints including an AirRush and a playing cue with two shafts. Because the AirRush butt uses a Uniloc joint to separate the front and back parts of the butt, I can remove the back portion of the butt and attach that to my extra playing shaft for a short playing cue that is a legal 41" or so. Don't need that where I play currently but not bad thing to keep in the back of my mind should the need ever arise.
But, that cue also isn't legal. 40" minimum length for a cue. Now for bar pool likely nobody cares, but just pointing it out.
As an aside, this post made me realize something kinda handy. I have a Predator setup that is all Uniloc joints including an AirRush and a playing cue with two shafts. Because the AirRush butt uses a Uniloc joint to separate the front and back parts of the butt, I can remove the back portion of the butt and attach that to my extra playing shaft for a short playing cue that is a legal 41" or so. Don't need that where I play currently but not bad thing to keep in the back of my mind should the need ever arise.
jordan11850
New member
I'll look into it, I've looked at the fishing pole cases, they're a little long.
Rusty in Montana
Well-known member
Just a thought , go to your favorite plumbing and heating store or hardware store and buy some 2" pvc pipe , a 2" pvc cap then a 2" clean out adapter with a screw in plug .
And use that for a case , then if you want it lined get some fleece material from a fabric store and get a sleeve made to fit .
It's a bit red neck but who cares it works and they're bullet proof for the most part .
I've used one similar for years ha ha
And use that for a case , then if you want it lined get some fleece material from a fabric store and get a sleeve made to fit .
It's a bit red neck but who cares it works and they're bullet proof for the most part .
I've used one similar for years ha ha
Last edited:
no. just carry it in like a dufus. you'll get all the action you want.
I bought a snooker cue case for my one piece Canadian Dufferin. I’ve got a dozen custom cues. The Duff is my favorite. A real sneaky Pete.