3D Printed Cue Extension

[td873]

I'd like to see a cue extension for the predator Air Rush. Going from the joint to a standard Length cue. from 51.5 to about 58 or 59"

I think something about 6" or maybe be able to put the other end of the joint portector on the top of it.

I did this for my jump butt. Now my extension rides in the main pocket. I had to make a bumper for the butt, but it works perfectly.

For my Propel, I made the extension ride on the top [screw into the extension bumper]. That also worked well.

-td

 

[td873]

It's M16x1.5 for the ones in the USA. IDK if it's different for the international market? Are you printing them? PLA or TPU? TPU will probably need a larger clearance. Printing usually is a hair big, and the threads often need slight adjustment. My threads were offset smaller .08mm on the radius. It took me several test prints to get the fit where I wanted it. I wanted a touch snug. For a bumper only, you'll probably want a touch on the looser side.

View attachment 880826

Onshape does a good job for this natively. In Fusion, I have to program new threads because I never liked the coil. But, when dovetailed with the canvas image, the programmed threads in Fusion do a great job.

-td

 

[Zerksies]

I did this for my jump butt. Now my extension rides in the main pocket. I had to make a bumper for the butt, but it works perfectly.

For my Propel, I made the extension ride on the top [screw into the extension bumper]. That also worked well.

-td

I'd like one for the joint end