Cue was made by William Lee. Ring work and butt cap were replaced by Kevin Wright in Georgia. It plays great and would suit someone that prefers a lighter cue.
Butt: 30"
OB-1 Shaft: 29"
3/8-10 Joint
I am not sure how much this cue weighs, but it is on the lighter side.
The butt has a few small dings, nothing bad. The shaft has lots of surface dings throughout and could probably use a refinish or cleaning if you don’t mind the surface dings near the joint.
SOLD
Butt: 30"
OB-1 Shaft: 29"
3/8-10 Joint
I am not sure how much this cue weighs, but it is on the lighter side.
The butt has a few small dings, nothing bad. The shaft has lots of surface dings throughout and could probably use a refinish or cleaning if you don’t mind the surface dings near the joint.
SOLD
Last edited:
