A finish that is grippy / sticky

Sensation

Sensation

right there
Silver Member
Hey everyone!

I have a 4 inch. extension on my cue, but it gets kinda slippery when I get nervous
🙃
What's an easy finish I can put on it to get a wrapless but "tacky" feel?
Lacquer? Floor poly? Epoxy?
I don't think I'd like any noticeable diameter to be added up to my cue extension actual diameter. I was thinking more clear coat, lacquer, epoxy, wax, cyanoacrylate, etc.
(I have somewhat of a lathe to help me out in the process)
 
Sensation said:
Hey everyone!

I have a 4 inch. extension on my cue, but it gets kinda slippery when I get nervous
🙃
What's an easy finish I can put on it to get a wrapless but "tacky" feel?
Lacquer? Floor poly? Epoxy?
I don't think I'd like any noticeable diameter to be added up to my cue extension actual diameter. I was thinking more clear coat, lacquer, epoxy, wax, cyanoacrylate, etc.
(I have somewhat of a lathe to help me out in the process)
Click to expand...
Try a rubber sleeve. Under $5 and not permanent if you don't. Usually used in wrap area. I see a lot on carom cues. Should be easy to find.
 
R2PQZ said:
Try a rubber sleeve. Under $5 and not permanent if you don't. Usually used in wrap area. I see a lot on carom cues. Should be easy to find.
Click to expand...
I checked ebay. Large selection. $10 to $20. Been awhile since I priced them. Variety of grip styles.
 
If you leave a rubber sleeve on your cue it could cause issues getting into or out of a case. Especially a JB case with his padded interior liner... On the extension it probably will not as it will not be slid into a case with it on the cue..
 
You must log in or register to reply here.
Back
Top