Adam/Balabushka Rhino shaft?

[Mr Machine]

My Adam’s Balabushka tribute cue.
So Rhino offers 3 different 5/16x14 joints.

Which will fit best without ordering their test fit kit?
The differences seem minimal but what do I know?

Or…. Does someone have the test fit kit that they loan or rent lol.

 

[garczar]

the standard should fit. the only smaller pins i've seen have been on schons and my jensen. its like a joss shaft going on a schon but not vice versa. the standard should go on about any 5/16x14.

 

[Mr Machine]

Thank you!

 

[gerard soriano]

I have 2 and they fit my Joss fine, the only issue I had was screwing it into my balance -rite extension

 

[skor]

I got the oversized one for various cues I have with the 5/16x14 joint (Schon, Jacoby, Scruggs, McDaniel). it was too tight and didn't fit any of them.
I had to tap it to fit.
Another thing to consider is that the diameter of the Rhino at the joint is 12.5mm which is wider than most 5/16x14 joints so the fit is not ferfect.

 

[Mensabum]

View attachment 845974
My Adam’s Balabushka tribute cue.
So Rhino offers 3 different 5/16x14 joints.View attachment 845977
Which will fit best without ordering their test fit kit?
The differences seem minimal but what do I know?

Or…. Does someone have the test fit kit that they loan or rent lol.

Standard will fit. So will oversized but you might find yourself tightening up now and then.

 

[Mensabum]

I got the oversized one for various cues I have with the 5/16x14 joint (Schon, Jacoby, Scruggs, McDaniel). it was too tight and didn't fit any of them.
I had to tap it to fit.
Another thing to consider is that the diameter of the Rhino at the joint is 12.5mm which is wider than most 5/16x14 joints so the fit is not ferfect.

I got lucky then. Fit mine perfectly.
Gift horses and all that.

 

[Mr Machine]

I got the oversized one for various cues I have with the 5/16x14 joint (Schon, Jacoby, Scruggs, McDaniel). it was too tight and didn't fit any of them.
I had to tap it to fit.
Another thing to consider is that the diameter of the Rhino at the joint is 12.5mm which is wider than most 5/16x14 joints so the fit is not ferfect.

I’m thinking that’s the other end?


Thanks for all the replies so far!

Now to prepare my PowerPoint presentation for the Minister of Finance….

 

[Jimmy_Betmore]

I’m thinking that’s the other end?


Thanks for all the replies so far!

Now to prepare my PowerPoint presentation for the Minister of Finance….

"In conclusion, approval of this funding is not only key to the long term well being of the Mr. Machine community, but it is a significant gesture towards the stabilization and growth of The Kingdom as a whole."

 

[skor]

I’m thinking that’s the other end?


Thanks for all the replies so far!

Now to prepare my PowerPoint presentation for the Minister of Finance….

Yeah, I ment 21.5mm at the joint while most cues are 21.3mm