Advice about Rambow needed!

[TwinkleToes]

Will any of you cue experts out there give me some advise as to what I should do about my new Rambow? The pin is slightly bent...it makes it look like the shaft is bent when I have them together but the shaft is fairly straight.

The pin is bent enough though...that when they are together, it makes it look like a very large warp. I don't know if I should leave it the way it is or try to get one of three or four great cuemakers in Houston to fool with it???

Would I be devalueing the cue if I have it worked on?

Thanks in advance,
TT

 

[Michael Webb]

check your pm's.

 

[poke&hope]

Rambow advice

I have one that has a bent pin also. I think the factory had specials on bent pins. Mike Gulyassy made a new shaft for me and off set the insert in the shaft to make it all come out straight. It takes a lot to impress me but he did it. I know it took a lot of extra I give a shoot to get it right. The shaft fit was excellent. Mike took the crook out of my hoppe but not my aim. I shoot just as bad as I did when I used to roll it over to the high spot before I shot. MIke G can do it.

 

[deanoc]

fix the pin