Any Ideas why my shaft will react like this???

[poolplayer2093]

Hi Mr. Ed,

Thanks for your advise. I have considered also the case that I put the cues into it. It was put in a Joe porper case. Maybe this case was not as good as my other cases that I used like whitten, predator, instroke case. The Porper construction inside is not like the others cases I have right now, so maybe the porper might be a one reason also? And also I never sand these 4 shafts that is infected.



Thanks for your advise again.:smile:

unless you're talking about the new predator case that's basically an instroke. from what i hear porper makes a damn good case. chances are the moisture that got to the shaft was just the moisture content in the air (just a guess)

 

[procues888]

unless you're talking about the new predator case that's basically an instroke. from what i hear porper makes a damn good case. chances are the moisture that got to the shaft was just the moisture content in the air (just a guess)

Hi,

As I have check the 2 cues with 4 shaft that was infected was placed in a porper case 3x6 and not predator case and I have a mistake that I think Ive mention that I put in a predator case earlier, sorry. But to be honest I was still confuse in this topic regarding the cases because the case I still have put other cues but other cues still the same and was not infected.

Maybe next time I will just be more careful in storing the cues that I collect, and maybe I have to put a machine like Humidifier, and a very nice cue case for the storing protection. Even still now I cant find the exact reason of the cause. Just to minimized the problem.

Thanks again .