Bludworth pin question

[ctyhntr]

I have a Bludworth, and it has a proprietary pin size. Searching the forum postings, it appears to be an undersize 3/8-11 1/2 with flattened thread peaks and sharp valleys; .348 x 11.445

What standard aftermarket shaft sizes will fit, or can be made to fit with minimal work? Or am I stuck with going custom?

 

[RBC]

We do the Bludworth joint in all our shafts.

http://www.obcues.com/products/OB-Classic-Plus-Shaft-Special-Order-Joint-(3-Weeks).html

It is a "Special", and takes a little longer, but we have done them for years.


Royce

 

[ctyhntr]

Royce,

I was not aware. I assumed even with your products, I would have to buy a blank and find a cuemaker to finish it off. Thank you for letting me know.

We do the Bludworth joint in all our shafts.

http://www.obcues.com/products/OB-Classic-Plus-Shaft-Special-Order-Joint-(3-Weeks).html

It is a "Special", and takes a little longer, but we have done them for years.


Royce