Can someone please help me identify this cue
- Thread starter sumdumgai
- Start date
That's just a regular McDermott base model, pin would be a 3/8 x 10.
McDermott E series or later...don't have time to look it up for you, Google it...:wink:
In pin store!
Hope it helps:smile::smile::smile:
Hope it helps:smile::smile::smile:
Wait a second, what is exactly a "joint connector" that you are looking for? There are "joint protectors". Are you talking about a SHAFT for the cue? As in the second half of it? When I said the pin was 3/8 x 10, the pin is the metal part that sticks out that the shaft screws into. You don't buy a pin unless you need to replace it.
If so you have a few options but I'm betting you just want a standard shaft without any LD stuff. I think the cheapest way to get a shaft for that cue is to buy a full Lucky cue off ebay or Amazon and then take the shaft from it. It will fit your cue.
Or if you want a better shaft with some low deflection properties, http://www.seyberts.com/products/Players_HXT_3/8_x_10_Black_Collar-102980-10483.html
Last edited:
Ask over in the Machinery Forum. Someone will probably offer to sell you a single.
Some Cue supply sites have a minimum order and shipping will make it not worth your while in most cases.
I am running low on 3/8ths x 10 or I would offer. If you end up in dire need, I will see what I can dig up.
Some Cue supply sites have a minimum order and shipping will make it not worth your while in most cases.
I am running low on 3/8ths x 10 or I would offer. If you end up in dire need, I will see what I can dig up.
