Cost to convert full splice?

Q-Street

AzB Silver Member
Silver Member
Just wondering what's the pricing to convert a full splice blank from a good cuemaker.
 
Theres a few good cuemakers on this site. Send them a pm with what you want.
 
JIM BUSS is a Forum Member, he is also one heck of a converter, check out this baby.





conversion.jpg
 
Last edited:
BIG range here. What do you want done to the cue in the conversion..ie, inlays, joint type, number of shafts, wrap type, hoppe ring, etc...way too many variables.

What cuemaker...even wider range in price depending on that choice. You probably start at around $750 and go to the moon.

Joe
 
Well, I'm not looking to have one done any time soon, but just would like to know. I neglected to mention the specifics to narrow the price range. How about supplying a blank to a cuemaker only to have phenolic buttcap, joint, and 1 shaft. 1 silver ring at abcde.
 
Q-Street said:
Well, I'm not looking to have one done any time soon, but just would like to know. I neglected to mention the specifics to narrow the price range. How about supplying a blank to a cuemaker only to have phenolic buttcap, joint, and 1 shaft. 1 silver ring at abcde.

If you want it to remain a full splice, you can only have rings at A/B/E. If they add rings at A/B/C/D/E, they will simply cut the cue and insert a maple handle. Lots of work, not matter what is done. No cuemaker that I know will do anything to a blank for less than $500. They figure it just is not worth the lathe time, etc for less than that.

Joe
 
Last edited:
Back
Top