Cue wobble

S

s_aaitama

Registered
Hi everyone, I have a Joss from the Crystal Leisure collection and recently I bought a ob2+ shaft from a person. The shaft and cue rolls straight apart but it wobbles when together. Can any cue maker or cuesmith advice me on this?

Warmest regards

Sent from my SM-G920I using Tapatalk
 
s_aaitama said:
Hi everyone, I have a Joss from the Crystal Leisure collection and recently I bought a ob2+ shaft from a person. The shaft and cue rolls straight apart but it wobbles when together. Can any cue maker or cuesmith advice me on this?

Warmest regards

Sent from my SM-G920I using Tapatalk
Click to expand...

if it rolls straight when apart and not when together and the pin also rolls straight when rolled then its a facing issue.
 
greyghost said:
if it rolls straight when apart and not when together and the pin also rolls straight when rolled then its a facing issue.
Click to expand...
I am suspecting it is a facing issue. The local pro shop sucks. Any idea how to fix it myself?

More information on the cue: it's a Joss so the joint pin is 5-16/14. The ob shaft however is flat faced and do not have a nub

Sent from my SM-G920I using Tapatalk
 
s_aaitama said:
I am suspecting it is a facing issue. The local pro shop sucks. Any idea how to fix it myself?

More information on the cue: it's a Joss so the joint pin is 5-16/14. The ob shaft however is flat faced and do not have a nub

Sent from my SM-G920I using Tapatalk
Click to expand...

find a local machinist who will face it off then or send it to a repair guy.....nothing you can do but mess it up worse without proper equipment.

gun smith would be a good choice for this actually if no local cue guys.
 
greyghost said:
find a local machinist who will face it off then or send it to a repair guy.....nothing you can do but mess it up worse without proper equipment.

gun smith would be a good choice for this actually if no local cue guys.
Click to expand...
Haha I'm not from United States, I'm from Singapore. The local qshop is useless smh. Anyway thanks for your advice, currently asking another few more repair guys that has lathe.

Sent from my SM-G920I using Tapatalk
 
The last 2 OB Shafts I sold needed faced for the same reason. After facing they rolled straight as a laser. Brian.
 
You must log in or register to reply here.
Back
Top