Mold Flash on Top Surface of Cushion
Flash, also known as flashing, is excess material attached to a molded, forged, or cast product, which must usually be removed. This is typically caused by leakage of the material between the two surfaces of a mold (beginning along the parting line[1]).
Should the Little Rib be trimmed away after install?
On the rails there was a light line all the way down the cloth of the cushion. Looked cheap.
Championship Tour Edition cushions on GCIV
Flash, also known as flashing, is excess material attached to a molded, forged, or cast product, which must usually be removed. This is typically caused by leakage of the material between the two surfaces of a mold (beginning along the parting line[1]).
Should the Little Rib be trimmed away after install?
On the rails there was a light line all the way down the cloth of the cushion. Looked cheap.
Championship Tour Edition cushions on GCIV
Last edited:
