Custom fabrication web site. Anybody used it???

Graciocues

Graciocues

AzB Silver Member
Silver Member
Anybody used this site for building jigs or special tooling.

Emachineshop.com

I was watching the Science channel and they had an show talking about future products and this web site was part of the show. I'm nervous to download the software.
 
EMachineshop

Graciocues said:
Anybody used this site for building jigs or special tooling.

Emachineshop.com

I was watching the Science channel and they had an show talking about future products and this web site was part of the show. I'm nervous to download the software.
Click to expand...

I tried the site out not to long ago. It appears legitimate and I had no bad experiences with the downloaded software. For me it required a pretty steep learning curve but someone more knowledgeable than I am would probabaly find it pretty usefull. I have since cleaned it from my hard drive with few, if any, artifacts hanging around.

Hope this helps.

Regards,
Stoney
 
I downloaded it a while back. I found their software easy to use, but not so easy that I could do what I wanted to do. As I recall, I was trying to do something involving tapering and couldn't figure it out. I'm quite tired of making tooling and would welcome the chance to get stuff made by them. I'd rather be cutting wood.
 
You must log in or register to reply here.
Back
Top