cut shot philosophy

When cutting an object ball, where do you prefer to strike the cue ball?

  • using Center Ball

    Votes: 46 31.3%

  • using High English

    Votes: 22 15.0%

  • using Low English

    Votes: 11 7.5%

  • using Outside English

    Votes: 60 40.8%

  • using Inside English

    Votes: 8 5.4%
  • Total voters
    147
Doesn't spin induced throw SIT increase the cut angle closer to 90 degrees?
Also doesn't force follow or draw also increase the cut angle?
 
LAMas said:
Doesn't spin induced throw SIT increase the cut angle closer to 90 degrees?
Also doesn't force follow or draw also increase the cut angle?
Click to expand...

High english can make you undercut the shot.Low helps try to keep the ball rolling more naturally.Speed is the key.
Helping english or outside also helps the ball roll more naturally again speed is the key.
 
Mikjary said:
Low outside on rail shots to cinch the ball. The draw makes the object ball climb into the pocket. If the ball is on or close to the rail, middle inside spin will also help the ball into the pocket when it hits the facing.

Best,
Mike
Click to expand...

I concur, I find that getting the OB to spin to hug the rail and or hit the short rail rubber and spin into the pocket is effective in pocketing the OB. Extreme outside english and extreme top and perhaps draw will accomplsh this.

Be well Mike.:smile::thumbup:
 
You must log in or register to reply here.
Back
Top