I have an old Brunswick centennial table that needs new rails (cushions)and was wondering where in Colorado I can bring them to have replaced. I use to use Showcase billiards but they are gone. Who does the best work as I expect top quality work?
Denver area table service?
- Thread starter mjdoutdoors
- Start date
Best Quality Billiards, Inc.10405 West Colfax Ave
Lakewood, CO 80215
(303) 233-2557
Open Weekdays 9:30am-6pm; Sat 10am-5pm
I would give these people a call.
Lakewood, CO 80215
(303) 233-2557
Open Weekdays 9:30am-6pm; Sat 10am-5pm
I would give these people a call.
9BallPaul
Banned
It's a family-run business that has treated me very well. The first table I bought had some issues, and Quint, the owner, backed up his warranty to the hilt.
My second table was built to my specs and I've been thrilled with it. Quint doesn't subcontract. All work is done by his employees. You can tell him I sent you.
Last edited:
Avoid Big Break Billiards and Woody's Billiards. I didn't have a good experience with either of them. They are adequate if you are looking for mediocre service. However, it's been a few years since I used either of them, so the hope would be that they have improved in their services.
I can't remember who Match-Ups in Fort Collins uses, but you could call Mike or Nicholle Hellmer and ask. Whoever services their tables does a great job.
I can't remember who Match-Ups in Fort Collins uses, but you could call Mike or Nicholle Hellmer and ask. Whoever services their tables does a great job.
table
Stop over to the -talk to a mechanic section on this site in the fourm area...
Most likely you have The table with cushions that are no longer in production or available anywhere" monarch cushions"...your sub rails must be calibrated to accept todays Style of cushions... Stop over and ask your questions...accept no other than a suggested mechanic in the talk to a mechanic section'
-
Rob.M
Stop over to the -talk to a mechanic section on this site in the fourm area...
Most likely you have The table with cushions that are no longer in production or available anywhere" monarch cushions"...your sub rails must be calibrated to accept todays Style of cushions... Stop over and ask your questions...accept no other than a suggested mechanic in the talk to a mechanic section'
-
Rob.M
I may be up in that area in the next month or 2, I would be able to modify your rails to accept today's cushions, and calibrate your rails so your table will be playing better than when it rolled off the factory floor.