Dr dent Buffer

needforspeed

New member
hi GUYZ,

I went to a local shop this afternoon and was told that they dun bring in anymore so i just try my luck here to see anyone have a spare one to sell :rolleyes:
 
mr2_serious said:
try using a shot glass...

Ditto.
seesaw.gif
 
Those work by making a real long dent so you don't feel it as much by compressing the wood around the dent. Small drops of water on the dent is the only way to get the dent out.
 
I would raise the dent with steam before using the glass. Seal some aluminum foil around a pot of water on your stove. Shape so the foil raises up in the middle and poke a small hole in the center with a tooth pick. Now bring the pot of water to a boil, and you'll have a jet of steam that you can direct fairly precisely. Place the dent into the stream for 5 seconds at a time, checking to see if the dent has raised up above the surrounding area. Once it has, then use the glass (or just sand w ultra high grit) to match the surrounding area. Don't apply more steam or water than you have to.

This works really well.
Mr H
 
Dents

A Q-tip dipped in water & a soldering iron does a fine job of raising the grain and limiting the amount of shaft you expose to moisture.
 
As everyone said it is a POS. It does more damage than good.

If you are still interested I will be glad to part with the one I have. Give me a PM and it is yours for a price of a beer plus postage.
 
Back
Top