Easy Setup to Make live Tenon threader for ferrules

Dacuban1972

Dacuban1972

New member
Last edited:
Way to use your noggin but I think I just got motion sickness. lol
I might suggest slowing that router down a little.....just a thought.
 
Eddie,

THANKS, what an ingenious idea! And it's not limited to 5/16-18 either!
Greenies sent!
:thumbup:
Gary
 
Very nice work and thanks for sharing. IMO the Pitch Diameter would be off and having the glue filling the voids.
Frank
 
The pitch of the threads can be changed by adjusting the compound
Slide on the carriage for the degrees of pitch for 5/16-18 is 0.05556.
Using a star thread cutter in the router is the best setup for this.
This was just a demo to help those who might not think it was
Possible and how easy to accomplish.
Thanks all
Eddie
 
Nice job!! Very good idea! and well executed. You should be able to tweak all the little stuff and make some very usable threads... I like it a lot!!
 
That has got to be one of the best ideas i have seen thus far. Even with me just starting out, i like that i can set that right up with relative ease.
Thanks.
 
Thanks '72, I think even I could replicate that:) ! Nice imagination! Just shows you the possibilities of this machine!
 
Interesting router mounting fixture. It looks like it squeezes around router to hold it? Where did you get that gadget?
 
You must log in or register to reply here.
Back
Top