F/S: 3/8"-16 tpi 12.5" long tap new/old stock

Terrific bargain, Dave. Thanks a ton for offering these up, I'm sure they'll all be put to good use.

Regards,
Frank
 
Dave38 said:
UPDATE: All state side orders are going to the post office tomorrow. I thank everybody and hope everyone is happy with them when they arrive.
Dave
Click to expand...

got mine today
thanks again dave

now, what's this tool used for? :rotflmao1:;)
 
To Brent, it is for treating Hemorroids. Just insert slowly, and rotate in a clockwise motion. Once you are at about 2" depth, stop and pull out sharply......:eek:
Seriously though, Glad you guys are happy. I did clean them up as they all had some surface rust on the shaft from sitting around, so I put them on my lathe and used a green scrubbie to remove the rust, and then applied a thin coat of tranny fluid on them and then wiped it clean. If any problems, just pm me.
Thanks,
Dave
 
You must log in or register to reply here.
Back
Top