I don't want to, but I need to put my BCM African Blackwood merry widow up for sale.
The cue is in nice shape, but it does have a few minor dings on the forearm and butt. The dings are minor, not deep (none are through the finish), but the finish at the very bottom of the buttcap shows some wear and there is one very small chip the finish in one of the bottom rings. These are minor, but they are there, so I want to mention them. Overall this is a very nice looking cue in very good shape.
The butt and forearm are African blackwood, and the cue has Bryan's nice railroad ringwork at A,B,C,D,E, it has a black leather wrap and comes with 2 BCM shafts. Length is Bryan's standard 58" with one shaft and 58.3" with the other. The cue has a 3/8x10 "greenish" G10 epoxy pin into wood, and a phenolic joint and butt cap.
Butt: 29" 15.2oz, with a .2oz weight bolt, 19.15 oz with either shaft, total weight.
BCM Shaft 1: 29.3 in., 12.44mm. 3.95oz. phenolic ferrule, Talisman hard tip. Very, very slight taper roll, less than 1/2 mm, doesn't effect playability at all.
BCM Shaft 2: 29 in., 12.8mm. 3.95oz. phenolic ferrule, Wizard medium tip. Straight.
The cue rolls straight together and apart, aside from the almost imperceptible taper roll in the thin shaft.
I'd like to get SOLD!! with two shafts or SOLD!! with the 12.44mm shaft, plus shipping or a reasonable offer for this. Please feel free to make a fair offer. I would consider a trade for an interesting MasonH cue, or something similar.
The cue is in nice shape, but it does have a few minor dings on the forearm and butt. The dings are minor, not deep (none are through the finish), but the finish at the very bottom of the buttcap shows some wear and there is one very small chip the finish in one of the bottom rings. These are minor, but they are there, so I want to mention them. Overall this is a very nice looking cue in very good shape.
The butt and forearm are African blackwood, and the cue has Bryan's nice railroad ringwork at A,B,C,D,E, it has a black leather wrap and comes with 2 BCM shafts. Length is Bryan's standard 58" with one shaft and 58.3" with the other. The cue has a 3/8x10 "greenish" G10 epoxy pin into wood, and a phenolic joint and butt cap.
Butt: 29" 15.2oz, with a .2oz weight bolt, 19.15 oz with either shaft, total weight.
BCM Shaft 1: 29.3 in., 12.44mm. 3.95oz. phenolic ferrule, Talisman hard tip. Very, very slight taper roll, less than 1/2 mm, doesn't effect playability at all.
BCM Shaft 2: 29 in., 12.8mm. 3.95oz. phenolic ferrule, Wizard medium tip. Straight.
The cue rolls straight together and apart, aside from the almost imperceptible taper roll in the thin shaft.
I'd like to get SOLD!! with two shafts or SOLD!! with the 12.44mm shaft, plus shipping or a reasonable offer for this. Please feel free to make a fair offer. I would consider a trade for an interesting MasonH cue, or something similar.
Attachments
Last edited:
