I recently had Andy Gilbert convert a couple of Titlist cues I had laying around and match them up to some nice shafts I had collected over the years. My idea on this one was to have him build a butt sleeve like the old Tad's or Gina's so he could save enough thickness at the joint to leave the cue wrapless and what he came up with really exceeded my expectations. The shafts are from the pre-split Joss shop and are very tight grained with that nice honey color and both have original Ivory ferrules. One of the shafts does have a slight roll but it was so nice I just had to use it.
The cue is 19.8 ounces with either 13mm shaft. Both shafts are 28 1/2 inches and the butt is 29 inches making a 57 1/2 inch cue. The joint is a 3/4 inch stainless steel with a 5/16-14 thread. It has a 1-1/2 inch delrin buttcap with a new old stock brown Brunswick bumper.
$1400 shipped and insured to the lower 48. Not really looking for trades. Paypal is fine. If not satisfied just return the cue in same condition within 48 hours for a full refund minus return shipping.
Reduced to $1250
Regards, Roger
The cue is 19.8 ounces with either 13mm shaft. Both shafts are 28 1/2 inches and the butt is 29 inches making a 57 1/2 inch cue. The joint is a 3/4 inch stainless steel with a 5/16-14 thread. It has a 1-1/2 inch delrin buttcap with a new old stock brown Brunswick bumper.
$1400 shipped and insured to the lower 48. Not really looking for trades. Paypal is fine. If not satisfied just return the cue in same condition within 48 hours for a full refund minus return shipping.
Reduced to $1250
Regards, Roger
Last edited:
