I'm selling this cue for a friend of mine. He's not good with computers and asked me to post this. And I'm not by any means, a Szamboti expert but I will try and answer any and all questions.
This cue is a basic 4pt ebony cue into a maple forearm. Ebony butt with a Delrin butt cap. Linen wrap. The cue was specially ordered from Gus by a road player with NO veneers so it would not attract attention.
It comes with 2 shafts. One is believed to be original (has a micarta ferrule). The other looks of the same era but the brass insert may have been cut back for the piloting. So it may not be a Szam shaft. It has an ivory ferrule. Note: The ivory ferrule has a hairline crack in it.
The cue has been refinished. While it looks very nice it was not done by a Szamboti so he understands this effects the overall value. When it was clear coated they coated over the delrin buttcap.
He is selling this for $5,000. Will consider going through an escrow service.
I will get some weights and diameters posted in a few minutes...
Diameter at butt: 1.249"
Diameter at joint: 0.841"
Shaft #1 w/Micarta ferrule
Diameter at base: 0.837"
Diameter at tip: 12.93 mm
Shaft #2 w/Ivory ferrule
Diameter at base: 0.836"
Diameter at tip: 12.35 mm
Note: hairline crack in the ferrule
Don't have any weights on hand. Batteries in scale are dead. I will try to get weights asap.
This cue is a basic 4pt ebony cue into a maple forearm. Ebony butt with a Delrin butt cap. Linen wrap. The cue was specially ordered from Gus by a road player with NO veneers so it would not attract attention.
It comes with 2 shafts. One is believed to be original (has a micarta ferrule). The other looks of the same era but the brass insert may have been cut back for the piloting. So it may not be a Szam shaft. It has an ivory ferrule. Note: The ivory ferrule has a hairline crack in it.
The cue has been refinished. While it looks very nice it was not done by a Szamboti so he understands this effects the overall value. When it was clear coated they coated over the delrin buttcap.
He is selling this for $5,000. Will consider going through an escrow service.
I will get some weights and diameters posted in a few minutes...
Diameter at butt: 1.249"
Diameter at joint: 0.841"
Shaft #1 w/Micarta ferrule
Diameter at base: 0.837"
Diameter at tip: 12.93 mm
Shaft #2 w/Ivory ferrule
Diameter at base: 0.836"
Diameter at tip: 12.35 mm
Note: hairline crack in the ferrule
Don't have any weights on hand. Batteries in scale are dead. I will try to get weights asap.




Last edited: