Sale pending.
Recently finished and ready to ship...
This was an unusual build because I decided to use holly for the front and back. Holly is commonly used for inlays and makes a great ivory substitute. I've had the holly used for this build for around 6 years. The holly and bocote were cored.
The specifications…
* Water buffalo tip.
* One inch juma ferrule (chalk resistant).
* One 12.6 mm x 29″ shaft.
* Shaft weight 4.0 ounces
* Modified 3/8 x 10 stainless steel joint pin
* Black phenolic joint and butt cap.
* Holly (cored) front and back.
* Three section bocote (cored) handle (grain aligned)
* Butt weight 15.1 ounces.
* Total weight 19.1 ounces (can be raised or lowered slightly).
* 29″ butt.
* Total cue length of 58″
* Twelve slot fancy nickel silver rings at A, B, C, D and E positions.
* Balance point at 19"
Your price $620 shipped (overseas shipping please add $20). Sale pending.
Recently finished and ready to ship...
This was an unusual build because I decided to use holly for the front and back. Holly is commonly used for inlays and makes a great ivory substitute. I've had the holly used for this build for around 6 years. The holly and bocote were cored.
The specifications…
* Water buffalo tip.
* One inch juma ferrule (chalk resistant).
* One 12.6 mm x 29″ shaft.
* Shaft weight 4.0 ounces
* Modified 3/8 x 10 stainless steel joint pin
* Black phenolic joint and butt cap.
* Holly (cored) front and back.
* Three section bocote (cored) handle (grain aligned)
* Butt weight 15.1 ounces.
* Total weight 19.1 ounces (can be raised or lowered slightly).
* 29″ butt.
* Total cue length of 58″
* Twelve slot fancy nickel silver rings at A, B, C, D and E positions.
* Balance point at 19"
Your price $620 shipped (overseas shipping please add $20). Sale pending.
Last edited:
