FS; Milk Dud Tips New Price
- Thread starter pooldawg8
- Start date
These are by far the best playing tips I have ever used! 
I need 10 pieces Jeff.
Medium bite hardness test.
Medium bite hardness test.
I've always liked these DawgDuds, but after getting into tip installation, trying all sorts of glue-ons, these are are better than I thought.
The dimensions are very well thought out, the tip cuts nicely, and they are a good hard tip that plays like a medium.
Not a bad tip for a glue-on...:smile:
The dimensions are very well thought out, the tip cuts nicely, and they are a good hard tip that plays like a medium.
Not a bad tip for a glue-on...:smile:
Glue ons??? You must have mastered the screw on tips with your new lathe and now you are on your way mastering "the glue on tips"!
Being left handed, I never could master the screw-on, and I don't like the way a slip-on cuts.
So I moved on to the glue-on's.
The Dawgdud's are pre-domed which makes my job easier, and I can do it left handed.
I'm still trying to figure out the slip on tips. I cant blend the ferrules with the shaft??
I'm still trying to figure out the slip on tips. I cant blend the ferrules with the shaft??
It takes quite a while.
Have Jeff send you some his new soaked and double pressed slip-on's.
Ordering nomanclature is DawgDud-S-O-II.
Then I can walk you through the DawgDud EZ-slip installation
They must be pretty good...
I would love to try these out sometimes!
(are you close to producing more, pooldawg?)
Geat milk duds.
They are the correct diameter too so I can use my 14MM tip installing jig.
The dome is near dead center.
PM sent, thx John
More blue cow please....
check your pm Jeff
check your pm Jeff