Hello! I recently purchased one of ten GC3's available from a guy locally, with lots of help (purchase wise and muscle wise) from the guys at TurnTable Billiards out of Atlanta. While we were loading everything, I noticed one of the 2x4 pieces that span the center of the frame was out-there were several pieces off to the side so I grabbed one that fit. Upon getting the table unloaded I noticed that the frame and it's corresponding pieces were numbered / matchmarked. I didn't grab the exact piece of wood that originally came with the table. Is that going to be a big problem? I know I got 3 matching pieces of slate. Thanks for the help.
GC3 Frame question
- Thread starter DallasHopps
- Start date
Reverend, thanks very much for your answer. The support seems to sit just a touch high, but I imagine it would be easy to sand or trim it down into the same plane. Nothing a good table mechanic wouldn't be able to get around! Thanks again
turntable billi
Registered
I could try and find you the number that u need Dallas but trying to match it would be impossible with out the frame? I think it will be ok when it's leveled. What kind of cushions do you plan on putting on it? I have to order 9 sets and I need 2 sets by wed. Let me know? Roy