G540
The G540 is a complete 4-axis system which plugs directly into your computer via the parallel port and to your motors through DB9 connectors. It contains four of our G250 drives, our own breakout board and a hard anodized aluminum case.
G540 Specifications:
- Four 10-Microstep motor drives
- 0 to 3.5A rated phase current
- 18VDC to 50VDC supply voltage
- Mid-band resonance compensation
- Auto standby current (70% current)
- Short-circuit protected
- Optoisolation on all LPT signal pins
- Two 1A at 0 to 50VDC rated outputs
- Four SPST to GND inputs (TTL)
- FAULT indicator LED,signal to PC
- POWER indicator LED
- I-SET resistor on motor connector
- TRIM adjust for motor smoothness
- Panel mount (5.7” by2.4” hole dim.)
- Anodized aluminum package
- No heatsink needed below 40C ambient
- Easy to service, removable drives
- Modular PCB design with no internal wires
- 10kHz watchdog timer (charge pump)
- Optoisolated analog output for a VFD drive
- Conservative ratings, premium components
This unit has a built in power supply and has been tested on 3 motors and a spindle. This is an American made controller that is brand new , ready to go. Tested with MACH3. Comes with four 12' DB9 cables.
I will take $400 or a complete wedge type axa Aloris QCTP. Must have at least 5 different tool holders.
The G540 is a complete 4-axis system which plugs directly into your computer via the parallel port and to your motors through DB9 connectors. It contains four of our G250 drives, our own breakout board and a hard anodized aluminum case.
G540 Specifications:
- Four 10-Microstep motor drives
- 0 to 3.5A rated phase current
- 18VDC to 50VDC supply voltage
- Mid-band resonance compensation
- Auto standby current (70% current)
- Short-circuit protected
- Optoisolation on all LPT signal pins
- Two 1A at 0 to 50VDC rated outputs
- Four SPST to GND inputs (TTL)
- FAULT indicator LED,signal to PC
- POWER indicator LED
- I-SET resistor on motor connector
- TRIM adjust for motor smoothness
- Panel mount (5.7” by2.4” hole dim.)
- Anodized aluminum package
- No heatsink needed below 40C ambient
- Easy to service, removable drives
- Modular PCB design with no internal wires
- 10kHz watchdog timer (charge pump)
- Optoisolated analog output for a VFD drive
- Conservative ratings, premium components
This unit has a built in power supply and has been tested on 3 motors and a spindle. This is an American made controller that is brand new , ready to go. Tested with MACH3. Comes with four 12' DB9 cables.
I will take $400 or a complete wedge type axa Aloris QCTP. Must have at least 5 different tool holders.
