Great deal on a McDermott with an I-2 and a standard shaft.

[poolfool1957]

I have no idea what model this cue is, I received it in a trade.
It has four veneered sharp points, a leather wrap and the standard 3/8-10 joint pin.
The I-2 shaft has a new 12.3mm UltraSkin Soft tip. The standard shaft has an unknown 13mm tip.
There is a little bit of taper roll in the I-2, not much and the tip does not leave the table. The joint collar matches up very close to the butt collar. No nicks or dents that I could see.
I have not rolled the standard shaft but it looks straight. This joint collar is slightly smaller than the butt collar....not much. A couple of dents but nothing of significance
The butt has a couple of really small indentations that dont break the finish. There is a scuff just below the wrap....again, no big deal.

The butt weighs 14.7oz
The I-2 weighs 3.2oz
The standard shaft weighs 3.8oz

SOLD firm shipped/paypal......this is a great price on a good "take it to the bar" cue.

 

[DelaWho???]

Looks like one of the Cornerstone cues Bill had made with D series parts. Looks like a D16 forearm. Doesn't look CNC but hard to tell with the posted pic. Points look sharp. The I shaft came off of something else as it has the ring in the collar.

Great buy @ $175