So, I purchased a used gold crown ii for Christmas but the two bar and two bolt assembly needed to tighten corner blinds is missing. I can fabricate a new one but I have no clue as to the dimensions of the plate, distance between bolts or the size of the bolts. any help would be greatly appreciated. I can find oem ones for $20 apiece but I'm not spending $80+s&h for something I could make for $2.00. I just need dimensions.
H e l p fabrication !
- Thread starter mmmbrains
- Start date
Go get you some 1/8" x 3/8" flat bar from Home Depot and cut 2 pieces long enough to cover from the top to the bottom of the flanges on the rail at the corner. Drill and tap 1/4 by 20 threaded holes in them on one bar, and 1/4" non treaded matching holes in the opposite bar matching the threaded holes in the first flat bar. Use 3/4"x 1/4" x 20 bolts to clamp the bars on the flanges to hold the corner together.
PS. There's 4 of them on the table, if one is missing, copy one of the other 3 to look the same.