Had to move and can't finish my cue.

Lexicologist71

Lexicologist71

Rabid Schuler fanatic
Silver Member
I was done with the construction of a butt but had to move. It is slightly out of round. (I thought I tracked the problem down but I was mistaken.) What would you charge to make it round and finish with a Z2 shaft? Remember, PM only. Also, I am in Columbus, Ohio now.
 
I am too busy to take on the work. But I am curious if you got rid of your equipment, or will you be setting back up your shop?
 
Lexicologist71 said:
I was done with the construction of a butt but had to move. It is slightly out of round. (I thought I tracked the problem down but I was mistaken.) What would you charge to make it round and finish with a Z2 shaft? Remember, PM only. Also, I am in Columbus, Ohio now.
Click to expand...
paul, if you can make the trip,
come on down to cincy sometime
 
I can help you with the Z shaft, 1st Gen or 2nd, your call.
Not for free of course but at the best price you'll likely get.
Brent or I could build it, either or.
Depending on ring-work and Gen choice, we may be able to get the shaft from stock.

LMK, KJ
 
Last edited:
Chris, I'm not throwing in the towel yet but work is suspended for now. I may be parting with some wood to make the next move easier. My curly oak is staying though.

As for which generation shaft, I have no idea. It will be my first. The joint is solid black and will have 5/16-14 screw.
 
This is the cue in question.
 

Attachments

  • image.jpg
    image.jpg
    99.7 KB · Views: 308
And I'm not dead set on Predator brand. It's just what came to mind when I was writing and that's what my friend let me borrow.
 
You must log in or register to reply here.
Back
Top