Heubler diameter at the joint?

H

hejests

AzB Silver Member
Silver Member
Hey guys,

Just wondering if anyone might know off hand what heubler's sneaky petes were sized at the joint? I'm just trying to figure out if a 5/16x18 ob-1 would fit relatively flush, they're ~.830" at the joint.

Thanks

Serge
 
I have 2 Huebler sneaky's and the joint diameter is quite a bit larger on one compared to the other, you may want to measure the exact cue you're looking at.
 
magnetardo said:
I have 2 Huebler sneaky's and the joint diameter is quite a bit larger on one compared to the other, you may want to measure the exact cue you're looking at.
Click to expand...
Thanks for the reply... I'll just wait till to the one I picked up on ebay gets here...
 
hejests said:
Hey guys,

Just wondering if anyone might know off hand what heubler's sneaky petes were sized at the joint? I'm just trying to figure out if a 5/16x18 ob-1 would fit relatively flush, they're ~.830" at the joint.

Thanks

Serge
Click to expand...

Hey Serge, Heubler shaft have always been made to fit each cue. They have never really use a standard joint diameter. I have seen them vary from as large as .860 thousands to as small as .815 thousands. The only way to figure this out is to have the joint measured with Calpiers.

Good Luck!!!!
 
You must log in or register to reply here.
Back
Top