How tight are your corner pockets?

[juanbond]

By "your" corner pockets, I mean whatever table you play on the most, whether you own the table or not. Sure, measurement procedures vary, but typically just measure between the points.

 

[BWTadpole]

4.25 inches on the two tables I play on most frequently. Shimmed Gold Crown IV's

 

[JimS]

The specs say 4 9/16 for my Diamond Pro but my calipers say 4.5 max.

 

[atthecat]

4 inch on my Brunswick Anniversary Table.

 

[tjlmbklr]

I had my pockets tightened the correct way too. I paid big money to throw my old rubber away to extend my sub rails a 1/4" on all sides. This resulted in 1/2" smaller pockets. The one thing my table always had as an issue is the same thing I have seen on all Olhausen; pocket rattle! So to tighten them up was almost the kiss of death. The tables pockects played harder then the Gold crown at league before I tightened them. So what does this tell us. Is the angle different? Is the shelf deeper?

I love my tight pockets but wonder sometimes if it really helps.

 

[poolhustler]

4"

 

[PoolBum]

3 and 7/8 inches.