So I’m trying to square up the rails on my gold crown. The manual says to use a carpenters square. I’m using a 2x3’ square. So I have the rails laid out and I’m putting a piece of one by under it to lift the square in the air. I have two sides pretty good I think. There’s one corner I can not get close. Do I need to put shim between the joint? It seems to square to the same spot after snugging the rails. I can’t find anything on the forum for squaring the rails up. You tube it looks like people match the corners up and tighten it. Then align the center pockets. Any help would be appreciated .
Thanks
Thanks