Hypothetically: can a "regular" shaft be made LD?

[dquarasr]

I understand that the primary factor in making a cue shaft LD is low mass at the front of the cue. This can be achieved via multiple factors: thin diameter; hollow core near the tip; very short ferrules.

So, hypothetically, can an already relatively thin diameter wooden shaft which does exhibit a fair amount of deflection be made LD by (in priority order):
- shortening the ferrule
- hollowing out the ferrule and possibly some of the wood of the end of the shaft
- shaving some of the outside of the shaft / changing the taper
?

 

[Patrick Johnson]

I think boring a hole in the tip end of the shaft is most effective. My 10mm tip is hollowed and I also had a small (1/4” long), thin ferrule installed.

Works great (20” pivot length).

pj
chgo

 

[Cornerman]

I understand that the primary factor in making a cue shaft LD is low mass at the front of the cue. This can be achieved via multiple factors: thin diameter; hollow core near the tip; very short ferrules.

So, hypothetically, can an already relatively thin diameter wooden shaft which does exhibit a fair amount of deflection be made LD by (in priority order):
- shortening the ferrule
- hollowing out the ferrule and possibly some of the wood of the end of the shaft
- shaving some of the outside of the shaft / changing the taper
?

The answer is: of course. The “hollow core near the tip” is normally just a drilled hole 5-6” down the axis. That can be done on any wooden cue.

If you’re thinking about shortening the ferrule, you might as well drill a hole. You need obviously the right tools and some skills.


Yes, you can also shave material on the outside. That was a common method before people were truly understood how to get a low squirt shaft. People would find that if they re-tapered the shaft to more of a constant taper or a European taper, the result would be lower squirt. They thought it was the stiffness, but that’s not what it was. It was the simple fact that they were removing material off near the tip end.

You could, of course replace your ferrule with a lower density ferrule, which would be Meucci and the OB method.

 

[sbrownn]

I would keep your original factory maple shaft as is and contact https://dominiakcues.com/ stating what you want. He did a light roasted Kielwood shaft to my specs below $200 shipped. He also makes LD shafts and these that look to be a Kielwood LD hybrid:

Radial Laminated Taper Shaft/ Roasted Torrified/ Hard Maple

Radial laminated "Right Roasted" hard maple. These are straight taper shafts measuring 30" long , 1" at the joint and .750" at the ferrule Cut your own profile on these . Eight piece straight grain, hand built in the USA Stafford NY We offer these in 3 grades. The AA grade is the very best...

dominiakcues.com

 

[dquarasr]

I have a local cue maker. I can get another CF shaft (already have one I really like) but this was more of a curiosity for me then an actual need. Hence, the hypothetical nature of my inquiry.

 

[Quesports]

A good friend has a Joss cue with one original shaft. It was the straightest lowest deflection shaft I have ever shot with.

I offered him 2500 for it he turned me down. I countered that offer for just the shaft for 2000. He turned me down again.

I suspect that bastard still has that cue! Even called and spoke with Dan Janes about it. He told me once in every once in a while the stars all align and the perfect shaft happens.

He and I had a good chuckle about my offer for the shaft!
I’m still thinking about it now!!!! Damn it…