i have a question

[tattoo]

is it hard to fix a cue that rolls out 1/16 at the point were the forearm meets the rap...short splice cue? just wandering if this an expensive fix or a fairly easy fix... had cue spun on lathe and it is very slight but i want perfect...thanks for all the help if you need more info to answer question please ask..thanks mickey carroll

 

[patrickcues]

Did you use a indicator and measure how much it was out? Is there inlays in the cue? What kind of cue is it?

 

[tattoo]

i will post pics of cue...roll out is where the ring inlay and the wrap meet.no indicator used just had local cue maker look at to show me were it was rolling out at...

 

[BarenbruggeCues]

Looks like a TAD. Have you contacted them? That's the first place I would start. If you can't get satisfaction there then choose your repair place wisely and don't let a few dollars be your determining factor on who does the repair. Based on what I'm hearing you say is the cue probably would need to be cut and a new handle installed to bring it back to original specs.
Not an inexpensive repair but not one that would over shadow the cost of a straight TAD of this design.
Definitely contact them first as I do know this.....TAD will not touch a cue that has been worked on by anyone else. Not even a wrap change!

 

[Mc2]

Down at Jensen cues in Baton Rouge

Mike here at Jensen Cues is telling me that this is an easy fix. He would be happy to help. Give hime a call 225-924-4517 at a decent hour.

thanks, Jim.