Is this a 5-16-14 insert? Revo
- Thread starter mikeiniowa
- Start date
5/16 14 only refers to the diameter and threads per inch, right?
pj
chgo
pj
chgo
That's what I thought it was.
Should work if the insert is only threaded at the deep end. What ^they^ said IOW...
What's the pin on the butt look like? Did it screw in normally with its OEM shaft?
If you or a friend have Uni-Loc Quick Release jointed cue, your shaft may fit that as well.
i have a non-Predator shaft which fits both.
i have a non-Predator shaft which fits both.
Wow. That doesn't make any sense. The only thing I can think of is somehow the insert is defective? I'd return it.
Not strange at all. A simple modification to the insert is all it takes.
Unisert inserts have been used for a few years now by some of us. I started doing them for people with two cues. One uni loc quick release and one 5/16x14. It was introduced on AZ as well.
Attachments
The Mali 5/16x14 was smaller in diameter but the quick release brass insert also fit the standard 5/16x14. I bought 100 of them when Mali closed.
Kinda seems like it’s Pechauer, or Jackson style insert.
If part of the joint screw had a solid shank to it, I would agree.
Even China sought of copied Pechauer only they use a metric thread M8x1.25
Attachments
Ma
If you were getting vibration from the part that's bored out for Pechauers shank on thier joint screw.
Which is roughly .320 or .321 for just short of a 1/2 inch.
And regular 5/16x14 joint screws range from .307 o.d. to .310 o.d.
Food for thought!
Makes sence. The only concern is,
If you were getting vibration from the part that's bored out for Pechauers shank on thier joint screw.
Which is roughly .320 or .321 for just short of a 1/2 inch.
And regular 5/16x14 joint screws range from .307 o.d. to .310 o.d.
Food for thought!
Meh, I’ll accept the apology. Realistically, if it’s acceptable tolerance at the joint, and seats tight. It should be fine. As far as acceptable as for what was ordered, no.