Joint/pin on break cue

[twal]

I see a lot of break cues have the 3/8 x 10 pin or even a radial pin.
Is there any special reasoning/benefit for this?
Is there any benefit of either of these over different pin?
Or are that just easier for a cue builder to make?
If taboo, just send me a pm and I will keep it quite

I know at the end of the day the pin/joint just connect the butt to shaft.
I am just curious on why these are so popular.

 

[whammo57]

I use 3/8-10 pins because when I reach in the drawer for a joint pin, one of them comes out in my hand. So I install it.

LOL

Kim

 

[twal]

Okay, that is kind of what I thought.
Just needed to confirm it.