Keith josey cues joint diameter

[Cezar Morales]

Hi, does anyone out there knows the joint diameter of Keith Josey cues ?

Thanks

 

[9Ballr]

Hi, does anyone out there knows the joint diameter of Keith Josey cues ?

Thanks

I don't know but I do know that I have a 314-3 that seems to fit it just perfectly.
So if you know the diameter of the new 314's you'll know what he uses.
Well, at least in my case and I didn't order anything special.
Just a regular sneaky.

 

[pwd72s]

Just measured my shaft where it meets the lower half with my cheapy Chinese calipers. I got 21.48 mm or .845 inches. Mine one of Keith's 4 point cues, made in 2007. Hope this helps.

 

[Cezar Morales]

Just measured my shaft where it meets the lower half with my cheapy Chinese calipers. I got 21.48 mm or .845 inches. Mine one of Keith's 4 point cues, made in 2007. Hope this helps.

Thanks. Really appreciate your effort n time in doing so.

Reason why im asking is im selling one of my josey shaft and a potential customer is asking me if it would be flush with his pat diviney cue which also uses a radial pin.

 

[Shawn Armstrong]

Thanks. Really appreciate your effort n time in doing so.

Reason why im asking is im selling one of my josey shaft and a potential customer is asking me if it would be flush with his pat diviney cue which also uses a radial pin.

Ask skins, but I think he uses a standard .840" joint, like pretty much everyone else.

 

[billiardthought]

Thanks. Really appreciate your effort n time in doing so.

Reason why im asking is im selling one of my josey shaft and a potential customer is asking me if it would be flush with his pat diviney cue which also uses a radial pin.

I have 3 Diveney cues. two @ .845 and one a little less around .835

 

[Banger]

My pretty darn accurate dial caliper says .841", on my Keith Josey sneaky.

 

[pookster]

I think it's 850 at joint

 

[The Milk Man]

Thanks. Really appreciate your effort n time in doing so.

Reason why im asking is im selling one of my josey shaft and a potential customer is asking me if it would be flush with his pat diviney cue which also uses a radial pin.

I have had 2 diveney's and 4 josey's and switched shafts between them. All of mine fit flush.

 

[Fuji-whopper]

If it's a Uni-Loc radial pin and he used the sanding jigs, the joint should measure .842".


Neil

 

[skins]

.......... .845

 

[Cezar Morales]

Thanks for all ur help n the response guys !
Really appreciate it